Servoguide Mark-Ⅳ D-Series PNEUMATIC-HYDRAULIC TYPE

Servoguide Mark-Ⅳ D-Series
PNEUMATIC-HYDRAULIC TYPE

NIRECO VIET NAM: http://www.nireco.com/en/company/overseas.html

Overview　|　 Feature　|　 System Components　|　 Specifications

Overview

The Servoguide MK-IV is a new type of hydraulic controller which embodies our long experience and technology in the field of web control.

The Servoguide MK-IV.D is a pneumatic-hydraulic Edge Position Control(EPC) device. The edge sensors are pneumatic, which gives them an extremely simple structure, while the controller is a robust, yet highly responsive, hydraulic unit. Control is precise and maintenance is simple.

D053
Low load type
Model D053, priced lowest among the Servoguide series, is a controller for low loads.

D121 
Syngle type
Model D121 is the standard model of the Servoguide MK-IV series, which can be used for most machines.

D226
Twin type
Two Servoguide MK-IV controllers are mounted on one hydraulic pump unit in the model D226. Economical and compact instrumentation can be obtained when more than one EPC system(eg. laminator line, multi-stage guide roll, etc.) is installed nearby.

D721
High load-type
Model D721 is a high-power Servoguide which can be applied for high loads and high-speed lines.

Feature

• Compact and inexpensive.
• Excellent control accuracy (control within ±0.1mm according to installation conditions).
• No contact between sensor and web.
• Very easy installation and maintenance.
• Large operating force and high sensitivity and accuracy.
• All hydraulic devices are incorporated in the oil reservoir, thus eliminating oil leakage.
• Quiet operation due to the special construction that prevents noise emission
  (Operating noise level : below 65 dB (A)).
• Use of a long-Iife and easy-to-maintain non-contact rotary blower allows clean air to be supplied.
• Use of a general-purpose motor makes all models explosion proof and increases safety.

System Components

AC〔AUTO-CENT〕REMOTE AUTO / CENT SWITCHING MODE

This system is available with centering operation as well asautomatic operation. The reel or the guide roll stand is automatically restored to the center position by selecting CENT with the selector switch when setting a mill roll, changing the width of a wed, or splicing webs.

AM〔AUTO-MAN〕REMOTE AUTO / MAN SWITCHING MODE

In this system, the Servoguide MK-IV. D controller can be remotely switched off during automatic operation or the reel stand can be moved right and left, when setting a mill roll or splicing webs.

Specifications

Servoguide Mark-Ⅳ D-Series PNEUMATIC-HYDRAULIC TYPE